# How to Use a Gas Powered Post Driver | RediDriver

> How to run a RediDriver gas powered post driver: straight unleaded fuel, 10W-30 oil, EP 0 grease, recoil start, hearing protection and yearly service.

Source: https://redidriver.com/how-to-use-redidriver/

---

## How to use RediDriver

### Fuel and fluids

- **Fuel:** straight unleaded gas. No mixing.
- **Engine oil:** 10W-30.
- **Hammer and crank lubrication:** EP 0 low viscosity grease. Use **only** EP 0, do not substitute.
- **Start:** recoil. All models use inclinable technology, so the engine runs at any angle.

### Care

- **Cleaning:** clean after each use to remove dirt and debris.
- **Service interval:** annually, especially with frequent use.
- **Storage and transport:** turn it off and secure it so it cannot move. The Tuff Box is built for this.
- **Conditions:** avoid heavy rain or submerged conditions.

### Protection

- **Noise:** over 100 dB. Hearing protection is required.
- **Vibration:** handles are spring isolated.

### Reach

The handle extension kit adds 4 feet of overall length, enough to drive 8 to 10 foot posts from the ground and get the ladder off the truck entirely.
